25 Aug Commonwealth Drive, Warrendale, PA SURFACE VEHICLE STANDARDSTA NDARD J REV. DEC83 1 Dec Buy SAE J Hardness Tests And Hardness Number Conversions from SAI Global. SAE J Hardness Tests And Hardness Number Conversions. Be notified when this Standard is updated or amended – Add to StandardsWatch. General.
|Published (Last):||8 April 2012|
|PDF File Size:||11.54 Mb|
|ePub File Size:||8.70 Mb|
|Price:||Free* [*Free Regsitration Required]|
The accompanying conversion tables for steel hardness numbers are based on extensive tests on carbon and alloy steels, mostly in the heat treated condition, but sae j417 been found to be reliable on practically all constructional alloy steels and tool steels in the as-forged, annealed, normalized, and quenched and tempered conditions, provided they are homogeneous.
Where more precise conversions are required, they should be developed specially for each steel composition, heat treatment, and part. However, because of the historical precedent and continued common usage, force values in kgf units and ball diameters sae j417 inch units are provided for information and much of the discussion in this standard refers sae j417 these units.
This report sae j417 approximate hardness conversion values; test methods for Vickers Hardness, Brinell Hardness, Rockwell Hardness Rockwell Superficial Hardness, Sae j417 Hardness; and information regarding surface preparation, specimen thickness, effect of curved surfaces, and recommendations for Rockwell surface hardness testing for case hardened parts. Historical Version s – view previous versions of standard.
Cart products product empty. This information may correlate to tensile strength, wear resistance, ductility, and other physical characteristics of metallic materials, and may be useful in quality control and selection of materials. Rockwell Hardness Standardizing Machines.
The tables in this report give the sae j417 relationship of Vickers Brinell, Rockwell, and Scleroscope hardness values and corresponding approximate tensile strengths of steels. Standardization of Rockwell Indenters. Sae j417 Item s – proposed revisions of this standard.
sae j417 It is the responsibility of the user of this standard to establish sae j417 safety and health practices and determine the applicability of regulatory limitations prior to use. Verification of Rockwell Hardness Testing Machines.
SAE J Hardness Tests And Hardness Number Conversions_图文_百度文库
Standardization of Rockwell Hardness Test Blocks. Specials NAS Rev. Currency Dollar Euro Pound. The same type and size indenters may be used for either test, depending on the scale sae j417 employed.
Link to Active This link will always route to the current Active version of the standard. It is impossible to give exact relationships because of the inevitable influence of size, mass, composition, and method of heat treatment. Welcome, Log in Your Account Cart: All numbers in these tables given in bold face type were prepared jointly by the American Sae j417 for Sae j417 and Materials, the American Society for Metals, and SAE from carefully checked data.
— Page Not Found
The significant differences between the two tests are that the test forces are smaller for the Rockwell superficial test than for sae j417 Rockwell test. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as sae j417 of the standard. Accordingly, throughout this n417, the term Rockwell will imply both Rockwell and Rockwell superficial unless stated otherwise. This standard provides the requirements m417 Rockwell hardness machines and the procedures for performing Rockwell hardness tests.
This standard specifies the units of force and sae j417 in the International System of Units SI ; that is, force in Newtons N and length in millimeters mm. New products AWS C1.